Teach you a method of cell phone film without leaving air bubbles

2. Check to see if there are any bubbles, or just scrape it off. After scraping, you can see that the film is intimately connected to your phone. In the same way, you can wrap the entire phone. First put a few drops of detergent water on the surface, then gently cover the film on the water, and then rub the water until there is water between the phone and the film (if you only use water, you will find it difficult to move ), knead the membrane to the correct position after completion (do not use too much water during this process, otherwise it is easy for you to knead into the phone keys)

Third, the next step is very important. We take the tool and scrape the water out from the middle of the membrane. Everyone should pay attention that the water will be scraped out of the membrane when wiping, and then scrape it out with a napkin. The purpose is to prevent water from entering the button. At this time, you can gently scrape some air bubbles out. After repeating for a period of time, the water must be almost completely scraped by you.

Fourth, in the end, as long as the water between the film and the mobile phone evaporates, it will be OK. After drying, you will be very happy to see the effect in front of you.
Even a novice who is just engaged in mobile phone beauty, who is not proficient in wrapping skills, can wrap the wrapping film without any bubbles.

Summary: detergent + water can be formulated into a so-called special anti-foaming agent. Why use detergent? First, it is colorless, and second, it has a lubricating effect, so it is very important to use it, and you can rest assured that after the detergent evaporates, it will not leave any traces. But don't use it to stick the screen. The detergent will corrode the screen, and the case is fine. Therefore, it is recommended that you still buy a digital special screen cleaning kit. How to use: Very important, must-see!

1. Wash your hands first and blow dry. Try to use a small fiber cloth to clean the dust on the surface of the screen in a dust-free environment; when wiping, wipe from one side to the other in order, do not wipe back and forth Remove some small particles or lint from the small fiber cloth before wiping).

2. Generally speaking, ① the film is the sticking surface, so first tear off part of the ① film (about 1/3), and stick it down carefully while aligning with the LCD screen (do not tear off all the ① film, first tear one part of the film) A small part, then stick to the bottom of the screen, press and hold the ② film to form an upward vertical triangle, while pushing, while tearing the ① film).

3. At the same time of sticking, it is necessary to press and remove the air under the veneer while sticking the film, while pushing and tearing off the film, carefully remove the air, so as not to leave bubbles and affect the appearance.

4. After pasting, you can tear off the top layer ② film.

5. Finally, use the lens cloth to flatten the periphery of the film.